Singer 93234 - Important Note

I
B
4. Using two hands, pull thread down into
thread guide post B until it snaps into the
round hole.
READING C
C
5. Holding thread secure at B, guide thread
down threading channel to tension sys-
tem C. Pull thread firmly up to top of
channel D, and then back down again.
_D
=
Before threading needle, test for proper
threading as follows:Pull a few inches of
thread through threading channel. Lower
presser foot to engage tension discs, then
pull a few more inches through. There
should be a noticeable difference be-
tween the thread tension when the press-
er foot is down and when it is up. If the
thread pulls through easily when the
presser foot is down, the machine is not
properly threaded and sewing problems
will result. Re-thread the machine and test
again.
IMPORTANT NOTE: If thread balls up in the bobbin case or knots up on the un-
derside of the fabric, the machine may not be properly threaded. DO NOT adjust the
thread tension until you have checked for proper threading using the test described in
Ste_ S. 13