1
/
USING ADJUSTABLE BLINDHEM
FOOT (K) (Optional Accessory)
RECOMMENDED SETTINGS
Stitch Selection: Zig-Zag Blindstitch
StitchWidth: II ! I I
It I
Stitch Length: _'--'--',-.--_.-_.,
Foot: Adjustable
Blindstitch (K)
Needle Plate: General Purpose (A)
With garment inside out, mark, fold and
press hemline (1).
Turn hem (1) back against inside of
garment, leaving 1/8" of hem beyond
fold (2), as shown.
Pin or baste all layers in place.
2
• Attaching Adjustable Blindhemming
Presser Foot (K). (See page 10.)
• Raise presser foot.
• Place folded edge (2) directly under
presser foot.
• Be sure bulk of garment is to the left of
needle.
Lower Presser foot.
Begin sewing slowly, making sure the
wide zig-zag stitch enters only the very
edge of the fold area (2). The narrow
zig-zag should fall in the hem area. If
this is not happening, adjust the position
of the foot.
Remove pins as you come to them.
25
To Next Page
Loading...
