Singer 93234 - SECTION 2: GETTING READY TO SEW; Connecting and Running the Machine

SECTION 2 GETTING READY TO SEW
CONNECTING THE MACHINE
Before plugging in your machine, be sure that the voltage and number of cycles indicated
on the electrical data lable (1), conform to your electrical power supply.
(2)
\
(1)
t
(3)
RUNNING THE MACHINE
Plug the controller (2), into the receptacle,
at the right end of the machine.
Then connect the electrical power cord
plug (3), to your electrical outlet.
Do not operate machine without material
under the presser foot as this may damage
the feed and the foot.
The machine and the sewing light are turned on and off by the same power switch.
0 I 0
POWER SWITCH
Power on-press "1" side of switch.
Power off-press "O" side.
To run the machine, press the speed
controller. The harder you press, the fas-
ter the machine will sew.
To stop the machine from sewing,
remove pressure from speed controller.
7