DARNING
You may mend worn or torn area easily when you follow with procedure suggested below.
RECOMMENDED SETTINGS
Stitch Selection: Straight Stitch
Stitch Width: II I _
II I
Stitch Length: .°..--'.--.'--'.-4,
Foot: Special Purpose (J) or
Darning and Embroidery (H)
Needle Plate: General Purpose (A)
Attach Feed Cover (F)
• If area to be darned is open, baste an
underlay in place.
• Place area to be darned under the
presser foot. Lower the presser foot and
start stitching• Alternately drawing the
fabric toward you and gently pulling
away from you until area is filled with
parallel lines of stitching.
• For additional strength, cover area with
crosswise lines of stitching.
ATTACHING DARNING AND EMBROI-
DERY FOOT (G) (Optional Accessory)
This foot permits better control of fabrics.
• Raise needle.
Remove presser foot with shank.
Guide Darning and Embroidery Foot (G)
from back of needle, with holding fork
(1) around presser foot screw, and lifting
finger (2) above needle clamp.
Tighten presser foot screw with coin.
To remove, loosen screw; guide foot
back.
Attach
Place
under
Feed Cover (F).
area to be darned, right side up,
presser foot; lower foot.
Stitch, guiding fabric back and forth, until
entire area is filled in.
37
To Next Page
Loading...
