25
Adjusting the Y-motor Gear
1. Remove the carriage cover.
2. Turn the power switch on and press the lettering
key and select Gothic font.
Enter 3 large “A” and press the OK key.
3. Insert a piece of paper between the tension disks
to unable the thread sensor and lower the presser
foot .
4. Run the machine and loosen the setscrew. While
the carriage is moving in the direction of the
arrow, adjust the Y-motor position so the gear
noise is lowest and tighten the setscrew.
5. Attach the carriage cover.
6. Press the home position key to move the carriage
to the home position.
8. Turn the power switch off and remove the piece
of paper.
If the machine is noisy when sewing an embroidery design, adjust the Y-motor gear as fol-
lows.
Home position key
Piece of paper
Setscrew
Y-motor
Carriage
movement
Setscrew
To Next Page
Loading...
