INTEGRATION WITH SKF @PTITUDE OBSERVER
Enlight Collect IMx-1 System View
SKF Enlight Collect IMx-1 System
User Manual
Revision A
In this view the upper area is a table of all gateways in the database (see also note
about external databases, below). The lower area lists sensors and can be filtered by
gateway or by hierarchical position:
• Filter by gateway:
o Select an entry in the gateway table/list: the associated measurement
and relay sensors for the selected gateway are shown.
• If ‘Link to hierarchy’ is on:
o In the Hierarchy view, select a machine or lower level node: if that
machine has a linked gateway, the measurement sensors associated
with it are shown. The sensor list is cleared if there is no gateway
linked to that machine.
o Important note: if an external database has been added, ‘Link to
hierarchy’ must be on for the gateway table to update and reflect the
gateways in the database that is currently selected by hierarchical
position.
Figure 13 Activate/deactivate link to hierarchy view
2.3.1 Gateways
For each gateway the following properties are shown in the gateway table:
Name: Name given to the gateway.
Self diagnostics status: Displays the latest reported self-diagnostic status or in
case of multiple errors the item considered most critical. "Ok" or an error in the
following priority order:
o Mesh module licence error.
o Missing/invalid network and identity configuration. This is a
configuration known as ‘configuration 2’, in the event log.
o Missing/invalid ‘other’ configuration. This configuration includes
measurement configuration.
o NTP Error.
The status field will initially be empty until the actual gateway status has been
received. Note that double clicking a gateway entry or selecting it and then choosing
To Next Page
Loading...
Need help?
General
