5.2.5 Certifications
Note that all the certifications listed below are pending or to be confirmed.
Europe
• Radio Equipment Directive (RED) and CE certified (radio, EMC and
product safety)
o Radio testing according to:
▪ EN 300328 for IEEE 802.15.4 Sensor radio
▪ EN 300330 for NFC
▪ The following only for Radiated Spurious Emissions
• EN 300328 for Bluetooth Low Energy
• EN 300328 for WLAN 802.11 b/g/n
• EN 301893 for WLAN 802.11 a/n/ac
• EN 301908 for UMTS band 1/8
• EN 301908 for LTE band 1/3/7/8/20/28
o EMC testing according to:
▪ EN 301489-1 general part
▪ EN 301489-3 for NFC
▪ EN 301489-17 for Bluetooth Low Energy, Bluetooth
Classic, WLAN 2.4 GHz, WLAN 5GHz
▪ EN 301489-52 for UMTS and LTE
o Health, exposure calculated according to:
▪ EN 62311
• RoHS2: assessment and documentation according to EN 50581:2012
• WEEE – Waste Electrical and Electronic Equipment Directive
(2012/19/EU): product marked according to EN50419
North America
• FCC/ISED certification
o EMC testing according to:
▪ FCC Part 15B/ICES003 Unintentional Radiator portion
o Radio testing according to:
▪ Simultaneous-transmission measurement
▪ Conducted Output Power and spot checks on Radiated
Spurious Emissions for antenna approval testing
▪ FCC15.225/including the correlation for ISED related to
NFC
FCC compliance statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
To Next Page
Loading...
Need help?
General
