Figure 25 Key sensor dimensions and example stud fixing options
The sensor mounting nut is 6-sided, “6-point”. When fitting the sensor to the stud,
always apply torque to that mounting nut rather than using the main sensor housing.
See also sensor environmental and physical specifications for other dimensional
data and spanner sizes.
3.3.3 Pre-commissioning tasks
Before any commissioning of sensors commences, each sensor location being
populated should have an associated machine/system location, in the database. This
pre-commissioning work should be done ahead of time so that the database is
populated with information on the sensor configuration and location. Prepare the app
by configuring connection details for that @ptitude Observer instance.
3.3.4 Commissioning
Assuming the sensor pre-commissioning steps have been completed and a
commissioned gateway is within range, once at the machine proceed as follows:
A. Launch the app. An earlier log in with network access is recommended.
B. Select ‘Scan Sensor’ function.
a. Bring the device close to the sensor to use NFC to wake it up, out of
flight mode.
C. After a period for Bluetooth search the ID of the sensor will be displayed.
Select it to connect and display sensor status and other information.
D. To commission it:
To Next Page
Loading...
Need help?
General
