INTEGRATION WITH SKF @PTITUDE OBSERVER
IMx-1 system configuration
SKF Enlight Collect IMx-1 System
User Manual
Revision A
• As well as being created, a relay node can also be deleted, by selecting it in
the IMx-1 System View and pressing the Delete button below the sensor list.
Figure 18 Sensor table example
All types of configured sensors allocated to a gateway will be shown in the sensor
table, as illustrated in the example shown above. When a sensor has been
commissioned the device MAC address will be reported in the Hardware ID column.
To edit or view the properties dialog of a sensor, select its associated gateway to
update the sensor list and then select the sensor from that list. Click the Edit button
below the sensor list or directly double click the table entry to open the sensor
properties dialog.
Figure 19 Mesh mode sensor example – IMx-1 System view properties
A mesh or leaf mode sensor is configured in the hierarchy so most settings/actions,
aside from Clear Hardware ID, are read only.
A second tab, Status, feeds back information on Hardware revision and Firmware
Version, Self-diagnostic status and when Created/Last updated/Synchronization
status changed. Note the information provided is updated on opening the dialog box,
not in real time.
Updating the sensor list by selecting the relevant gateway acts as a useful check that
the gateway is actually associated with the machines it should be. If it is, the
expected sensors will be displayed.
To Next Page
Loading...
