Figure 39 A typical terminal configuration for using the service interface
Reset to factory defaults
• At the login prompt, initiate the reset by using appropriate credentials for both
Username and Password. When needed, these credentials can be provided
by TSG.
Note: The gateway will respond with the message "Job for factory-reset.service
canceled." when it has completed the factory reset.
Other diagnostic commands and functionality
The Username and Password credentials used above are only valid for the ‘Reset to
Factory default’ functionality. Other diagnostic commands and procedures that from
time to time SKF may recommend or request, are subject to a secure logon with
credentials specific to the particular gateway.
W7 driver installation
• Have the USB driver installer utility: Zadig.exe, ‘no installation needed’ but
note that admin rights are still required.
• Whilst connected to the gateway, run it and install the Gadget Serial driver:
o The Zadig main drop-down will list any devices not already having a
driver, so from it select the "Gadget Serial" device, refer Zadig screenshot
below.
To Next Page
Loading...
Need help?
General
