PRE-RIDE INSPECTION
167
After Engine is Started
For proper engine starting procedure, refer to the appropriate
ENGINE STARTING PROCEDURE.
1. Check headlights high beam and low beam, taillight,
stop light and pilot lamps operation.
Note: You may need to detach tether cord from your clothes
to check lights. In such a case, attach cord as soon as you get
back at the controls of the snowmobile.
2. Check the engine cut-off switch (by pulling tether cord
cap) and emergency engine stop switch operation.
3. Release parking brake.
4. Refer to VEHICLE WARM UP and follow instructions.
Pre-Ride Check List
ITEM OPERATION
Body
includ-
ing seat,
footrests,
lights,
air filter,
controls
and in-
struments
Check condition and remove snow or
ice.
Skis and
steering
action
Check for free movement and proper
operation.
Fuel and
injection
oil (if ap-
plicable)
Check for proper level and no leaks.
Coolant Check for proper level and no leaks.
Brake
fluid
Check for proper level and no leaks.
To Next Page
Loading...
Need help?
General
