173
MAINTENANCE PROCEDURES
This section includes instructions for basic maintenance pro-
cedures.
WARNING
Turn off the engine, remove tether cord cap and follow
these maintenance procedures when performing main-
tenance. If you do not follow proper maintenance pro-
cedures you can be injured by hot parts, moving parts,
electricity, chemicals or other hazards.
WARNING
Should removal of a locking device be required (e.g. lock
tabs, self-locking fasteners, etc.) when undergoing disas-
sembly/assembly , always replace with a new one.
Engine Coolant
WARNING
Never open coolant tank cap when engine is hot.
Engine Coolant level Verification
Open the RH side panel, see CONTROLS, INSTRUMENTS AND
EQUIPMENT.
Check coolant level at room temperature with the cap removed.
Liquid should be at cold level line of coolant tank.
Note: When checking level at low temperature it may be
slightly lower then the mark.
If additional coolant is necessary or if entire system has to be
refilled, refer to an authorized Ski-Doo dealer, repair shop or
person of your own choosing.
To Next Page
Loading...
Need help?
General
