BASIC PROCEDURES
120
520001663-013_b
TYPICAL
Start engine as per usual manual starting.
WARNING
When starting the snowmobile in an emergency situation,
using drive pulley, do not reinstall the belt guard and return
slowly to have snowmobile repaired.
Vehicle Warm-Up
Before every ride, vehicle has to be warmed up as follows.
1. Start engine as explained in ENGINE STARTING PROCEDURE
above.
2. Allow engine to warm up one or two minutes at idle
speed.
Note: Engine will shut down after approximately 12 minutes
of idling.
3. Disengage parking brake.
4. Apply throttle until drive pulley engages. Drive at low
speed the first two or three minutes.
To Next Page
Loading...
Need help?
General
