Ski-Doo REV G4 Trail/Crossover E-TEC Series User Manual

MONITORING SYSTEM
251
Pilot
Lamp
ON
Beeper
Message
Display
Description
—
Short
beeps
repeat-
ing
rapidly
SHUT-
DOWN
Shutdown procedure
in force due to engine
overheating or fuel
pump problem.
DESS
2 short
beeps
—
Good key, vehicle
ready to operate.
Short
beeps,
repeat-
ing
slowly
WRONG
KEY
Unable to read key
(bad connection).
Make sure the key is
clean and correctly
snapped on post.
Short
beeps
repeat-
ing
rapidly
BAD KEY
Invalid key or key not
programmed. Use the
proper key for the
vehicle or have the
programmed.
— —
Fuel level sensor
problem.
(blin-
king)
Fault Codes
On the multifunction analog/digital gauge, fault codes can be
displayed on the center display.
To read any active fault code, press and hold MENU (M)
Button and simultaneously depress the HI/LOW beam switch
repeatedly several times.
If two or more codes are registered, use SET (S) or MENU
(M) to scroll.
To exit the fault codes mode, press and hold MENU (M) button.
Contact an authorized Ski-Doo dealer for code signification.

Ski-Doo REV G4 Trail/Crossover E-TEC Series Specifications

General

Brand	Ski-Doo
Model	REV G4 Trail/Crossover E-TEC Series
Category	Snowmobiles
Language	English