MAINTENANCE PROCEDURES
186
mmo2012-004-903_a
TYPICAL
1. Clamping bolt
6. Install drive belt guard.
7. Install side panel.
Note: These settings are correct as a preliminary adjustment
for most models. In some cases, when starting the engine, the
vehicle could creep, indicating that the drive belt is too tight.
If the vehicle creeps, lower the drive belt height from the
preliminary setting. Repeat procedure until creeping stops.
Reverse Activation
Note: The reverse may not activate if the belt is positioned too
high in the driven pulley. If reverse activation does not work
properly, ensure the drive belt is properly adjusted. Adjust the
drive belt lower in the driven pulley if needed.
To Next Page
Loading...
Need help?
General
