Ski-Doo REV G4 Trail/Crossover E-TEC Series User Manual

CONTROLS, INSTRUMENTS AND EQUIPMENT
94
520001897-001_a
DRIVE BELT GUARD TOOLS LOCATION
1. Suspension adjustment tool
2. Pulley expander
Install in the following sequence:
1. Slide the Suspension adjustment tool open end under
retaining tab.
2. Press the closed end on the retaining tabs.
3. Slide the Pulley expander and headlight adjustment tool
short end into hole.
4. Rotate and clip long end in place.
CAUTION
Make sure tools are secured properly. Tools may detach and
cause damage to rotating parts.

Ski-Doo REV G4 Trail/Crossover E-TEC Series Specifications

General

Brand	Ski-Doo
Model	REV G4 Trail/Crossover E-TEC Series
Category	Snowmobiles
Language	English