SKYJACK, Page 111
SJRT Compact Series
Engine Powered
When EZcal hand-held device is connected to the OCM1 control module, a two line displays shows various
menus and settings. At any time the top line of the display describes the currently selected menu and the bottom
line shows the currently selected item in that menu.
Six buttons on EZcal allow easy navigation through the menus:
and change the selected item (the bottom line display)
ENTER enters the selected new menu when available (top line display changes)
and adjusts the selected item when available
ESC exits the current menu back to the previous menu
TOP LEVEL MENU OPTIONS
HELP Select this menu to see a description of current OCM1 status
DIAGNOSTICS Select this menu to see switch input status & logged data
ACCESS LEVEL Select this menu & enter correct code to enable adjustments and calibrations
ADJUSTMENTS Select this menu to see and adjust OCM1 settings
NOTE: this menu provides for adjustments which might be needed for different
work activities
SETUPS Select this menu to carry out initial set-up of the OCM1
NOTE: this menu provides for set-ups which are needed to configure the OCM1
for a particular vehicle
HELP MENU OPTIONS
(help message) A message displays current OCM1 status, indicating if everything is OK or if there is
an error code (see LED Error Codes - Table 5.3)
DIAGNOSTIC MENU OPTIONS
SYSTEM Select this menu to see general OCM1 system information
SWITCHES Select this menu to see switch input status
OUTPUTS Select this menu to see OCM1 output status
LOG Select this menu to see logged information
DIAGNOSTIC / SYSTEM MENU OPTIONS
OUTRIGGERS Displays various status during the auto-level function
TILT Displays vehicle tilt in “X” and “Y” orientations measured by integral sensor
TILTED Displays whether vehicle is tilted (YES or NO)
BATTERY Displays battery supply voltage (on P2-12)
DIAGNOSTIC / SWITCHES MENU OPTIONS
LR/P2-1 High when the left rear outrigger is in contact with the ground
RR/P2-2 High when the right rear outrigger is in contact with the ground
RF/P2-3 High when the right front outrigger is in contact with the ground
LF/P2-4 High when the left front outrigger is in contact with the ground
EXTEND/P2-5 High to activate the auto-level function
RETRACT/P2-6 High to activate the auto-retract function
ELEV/P2-10 High when the scissor stack is stowed (“elevated” input indicates that the vehicle is
stowed).
5.9 Outrigger Control Module Instructions
Go to Discount-Equipment.com to order your parts
To Next Page
Loading...
