SKYJACK, Page 90
SJRT Compact Series
Engine Powered
4.1-39. Auto All Up Inoperative (Retract)
1. Loose or broken wire #35D from outrigger enable switch (S9A) to auto mode outrigger switch
(S24).
- Check continuity. Replace if defective.
2. Defective auto mode outrigger switch (S24).
- Check switch. Replace if defective.
3. Loose or broken wire #10A at PIN#P2-12 on outrigger control module (OCM1).
- Check for power at P2-12. If no voltage present, check continuity of wire. Replace if defective.
4. Loose or broken wire #35 at PIN#P2-12 on outrigger control module (OCM1).
- Check for power at P2-10. If no voltage present, check continuity of wire. Replace if defective.
5. Loose or broken wire #02 at PIN#P2-11 on outrigger control module (OCM1).
- Check for ground at P2-11. If no ground present, check continuity of wire. Replace if defective.
6. Loose or broken wire #70 from auto mode outrigger switch (S24) to PIN#P2-5 on outriger control
module (OCM1).
- Check continuity. Replace if defective.
7. For additional information, refer to section 5 “Outrigger Control Module.”
Go to Discount-Equipment.com to order your parts
To Next Page
Loading...
