ZB2044December 2007
Page 9
TM
Section 1 - About Your Telehandler Safety Rules
Electrocution Hazard
This telehandler is not electrically insulated. Use extreme caution around high-voltage overhead power lines
and maintain a Minimum Safe Approach Distance (MSAD) of 10 feet from source of power. Adhere to all federal/
national, state/provincial, or local safety regulations for your own protection.
No part of telehandler or payload should be brought closer to any energized overhead electrical conductor with
nominal phase voltage rating as specied below:
Voltage Distance
750 to 150,000 10 feet
150,000 to 250,000 15 feet
250,000 20 feet
DANGER
Never approach any power line with any part of telehandler. Use extreme caution; serious injury
or death can result with contact from any power line.
IMPORTANT
Always assume electrical power sources and overhead lines are energized.
DO NOT USE TELEHANDLER AS A GROUND FOR WELDING.
DO NOT OPERATE TELEHANDLER DURING LIGHTNING OR STORMS.
To order go to Discount-Equipment.com
To Next Page
Loading...
