Skyjack ZB2044 - 2.8-10 Boom Inspection; 2.8-11 Lifting Attachment Inspection

Page 32 December 2007
ZB2044
Visual and Daily Maintenance Inspections Section 2 - Operation
2.8-10 Boom
- Ensure there are no loose or missing parts
and there is no visible damage.
- Ensure all bolts and pins are properly
tightened.
- Ensure there are no visible cracks in welds
or structure and there are no signs of
deformation.
- Ensure all hoses are properly tightened and
there is no evidence of hydraulic leakage.
• Slide Pads
- Ensure all bolts are tight, there is no
visible damage to the slide pads and that
no parts are missing.
• Chain
- Ensure there are no loose or missing
parts and there is no visible damage
• Boom Angle Indicator
- Ensure all bolts are tight, and there is no
visible damage
2.8-11 Lifting Attachment
- Ensure there are no loose or missing parts
and there is no visible damage.
- Ensure attachment is properly positioned
and secured. (refer to Section 2.15 for
attachments)
2.8-12 Grease Points
Maintaining properly greased components is essential
for good performance and service life of the telehandler.
If components are improperly greased, it could result
in component damage.
WARNING
Ensure that there are no personnel or
obstructions in maintenance area.
Greasing intervals are based on telehandler usage
of 40 hours. Use of telehandler may vary signicantly
and greasing frequency must be adjusted to obtain
maximum service life.
Refer to service manual for complete list of grease points
locations and greasing schedule.
Refer to Table 2.4 for recommended fluids and
lubricants.
Boom Assembly
Lifting Attachment Boom Extend
Cylinder
To order go to Discount-Equipment.com