☐ The personal SMA Grid Guard code of the Installer must be available for the changing of
grid-relevant settings after completion of the first ten feed-in hours (see certificate "Application
for SMAGridGuard Code" at www.SMA-Solar.com).
Procedure:
1. Open the web browser of your device, enter the IP address of the inverter in the address line
of the web browser and press the enter key.
2.
Web browser signals a security vulnerability
After the IP address has been confirmed by pressing the enter key, a message might
appear indicating that the connection to the user interface of the inverter is not secure.
SMA Solar Technology AG guarantees that calling up the user interface is secure.
• Continue loading the user interface.
☑ The login page of the user interface opens.
8.2 Logging In and Out of the User Interface
After a connection to the user interface of the inverter has been established, the login page opens.
Log onto the user interface as described below.
Log in as installer or user for the first time
Procedure:
1. In the drop-down list Language, select the desired language.
2. In the User group drop-down list, select the entry Installer or User.
3. In the New password field, enter a new password for the selected user group.
4. In the Repeat password field, enter the new password again.
5. Select Login.
☑ The Configuring the Inverter page or the user interface start page opens.
Log in as the User or Installer
1. In the drop-down list Language, select the desired language.
2. In the User group drop-down list, select the entry Installer or User.
3. Enter the password in the field Password.
4. Select Login.
☑ The start page of the user interface opens.
Log Out as the User or Installer
1. On the right-hand side of the menu bar, select the menu User Settings.
2. In the subsequent context menu, select [Logout].
☑ The login page of the user interface opens. The logout was successful.
8Using the Inverter User Interface
SMA Solar Technology AG
Operating ManualSB15-25-1VL-40-BE-en-1146
To Next Page
Loading...
