SMA Solar Technology AG Operating the Sunny Island
Technical Description SI2012_2224-TEN082311 103
The password is dependent on the operating hours counter. In the installer level there are extended
access privileges to all necessary parameters.
Password = Sum of the digits of the number of operating hours.
Proceed as follows to enter the installer password:
The display shows the standard view 1.
1. Select the "200# Settings" menu.
2. Depress the knob.
3. Select the "260# Set Password" menu.
4. Depress the knob.
The following message appears:
• Two place holders (** ) for the password
(PW)
• Level [0] = user level
• Operating hours (OnTmh)
• Sum of all hours in operation
• Units
5. Calculating the password
Add up all the digits of the number of
operating hours. In this case:
1 +2 + 3 + 4 + 5 + 6 = 21
6. Press the pushbutton. The place holders
blink.
7. Enter the password (here: "21").
Turn the pushbutton to the right or left. The
value increases or decreases accordingly.
100# Meters
200# Settings
300# Diagnosis
400# Failure/Event
230# Set External
240# Set Relay
250# Set System
260# Set Password
PW:** Level[0]
OnTmh 123456 [h]
PW:21 Level[0]
OnTmh
123456 [h]
To Next Page
Loading...
