87
Installation instructions
ST1.5
XLED Home 2 Z Wave and IS 140-2 Z Wave are
set up using a control dial (Poti).
To do this, turn the control
dial from 0 to SET and back
again within ve seconds.
Note: If you have selected
“Synchronise Device” you
will be asked to adjust the
settings on your device.
Depending on the type of
device you have, set it up
using Z Wave as follows:
ST1.6
L810 LED iHF Z Wave and RS LED D2 Z Wave can be
set up by simply clicking on the SET button.
ST1.4
If required, you can change the name of your device.
Then, select Synchronise Device.
ST1.7
You will receive conrmation when the device
has been set up successfully.
To Next Page
Loading...