38
Installation instructions
A2.1
Smartvest Alarm Panel: The following conditions can be used
as a trigger in the IF section of the scene:
Smartvest Alarm Panel: The following conditions can be used
as an actuator in the THEN section of the scene:
Operating mode: part set,
disarm or arm
Alarm: inactive, active (burglar
alarm), panic, tampering, 24-
hour (re or water alarm)
Failure: No connection, incor-
rect password
Temperature/air humidity: =,
> or < the latest measurement
by the Smartvest Alarm Panel
Operating mode:
Part set, disarm or arm
Panic: Trigger panic alarm
A2: ABUS products in the “Scenes” view
A2.2
Smartvest Opening Detector The following conditions can
be used as a trigger in the IF section of the scene:
Opening Detector: Open,
Closed
Failure: No, Low battery, No
signal
Note: No conditions can be
used as an actuator in the
THEN section of the scene: