113 | CHAPTER 19 – THE SMART NOTEBOOK CONTROL PANEL
–The Standard orientation uses nine alignment points and provides a slightly
higher level of accuracy.
–The Wide orientation uses 12 alignment points and is suitable for wide-screen
products.
–The Fine orientation uses 20 alignment points.
NOTE
Some orientation levels aren’t available on some SMART products.
6. Press OK to close the control panel.
Changing Mouse Settings
Like a mouse, your SMART product's interactive screen acts as an input device. You
can change SMART hardware settings to customize the behavior of your SMART
product, including how it interprets the way you press the interactive screen.
You can customize mouse settings to achieve the following:
• Make it easier to double-click.
• Enable touch-and-hold right-click behavior.
• Disable pop-up messages.
• Enable Touch Recognition.
Changing the Double-Click Zone
The double-click zone is the area in which you must press so that SMART Notebook
recognizes two presses as a double-click, not two left-clicks. You can specify how far
apart you can press the interactive screen to perform a double-click.
To change the
double-click zone
1. Open the SMART Notebook control panel.
2. Press SMART Hardware Settings.
The upper area of the control panel displays an image of the SMART product
connected to the computer.
3. If your computer is connected to more than one SMART product, the upper area
of the control panel displays an image of each SMART product. Press the image
of the product with the settings you want to change.
4. Select Mouse Settings in the list.
To Next Page
Loading...