118 | CHAPTER 19 – THE SMART NOTEBOOK CONTROL PANEL
Setting Up Icon Strips
You can set up tool strips or custom icon strips on SMART products that support
them. Icon strips make it easier to access display, writing and drawing features from
the interactive screen.
You can change SMART hardware settings to customize the behavior of icon strips.
You can change the behavior of icons, reposition icon strips or remove icon strips at
any time.
Setting Up a Tool Strip
If your SMART interactive product supports icon strips, you can set up tool strips,
which make display, writing and drawing features easily accessible from the
interactive screen.
You can position tool strips inside the black border on the left, right or bottom edge of
the interactive product.
TIP
Make sure that the edge of the tool strip is aligned with the frame of the interactive
product.
To set up the tool strip 1. Open the SMART Notebook control panel.
2. Press SMART Hardware Settings.
The upper area of the control panel displays an image of the SMART product
connected to the computer.
3. If your computer is connected to more than one SMART product, the upper area
of the control panel displays an image of each SMART product. Press the image
of the product with the settings you want to change.
4. Select Set Up Icon Strips from the drop-down list.
5. Press Add.
The Available Strips dialog box appears.
6. Select Tool Strip, and then press OK to display the calibration screen.
7. Follow the on-screen instructions to define the corners of the tool strip.
NOTE
If you press the interactive screen too far from the edge of the icon strip, an
error message appears and you must try again.
8. Press OK to close the control panel.
To Next Page
Loading...