HGM9520N Genset Paralleled Controller User Manual Page 71 of 111
0: Gen Power (%); 1: Available Power.
(Not available for HGM9520N)
Schedule the load value of other gensets
when start the genset on demand.
(Not available for HGM9520N)
Schedule the load value of other genset
when start the genset on demand.
(Not available for HGM9520N)
Schedule the available power value of other
genset when start the genset on demand.
(Not available for HGM9520N)
Schedule the available power value of other
genset when start the genset on demand.
(Not available for HGM9520N)
It is frequency feedback coefficient in
configuring active power distribution.
(Not available for HGM9520N)
It is voltage feedback coefficient in
configuring active power distribution.
(Not available for HGM9520N)
0: None; 1: Warning; 2: Block; 3: Safety Trip;
4: Safety Trip and Stop; 5: Trip; 6: Trip and
Stop; 7: Shutdown.
(Not available for HGM9520N)
0: None; 1: Warning; 2: Block; 3: Safety Trip;
4: Safety Trip and Stop; 5: Trip; 6: Trip and
Stop; 7: Shutdown.
(Not available for HGM9520N)
If static paralleling is not completed during
“Static Parallel Delay”, controller will initiate
alarm information.
(Not available for HGM9520N)
0: Disable; 1: Enable
All gensets should be configured the same
economy fuel value.
(Not available for HGM9520N)
It is the economy fuel percentage of genset.
(Not available for HGM9520N)
Economy fuel consumption starts
exchange if difference value of the total
rated power of the exchange gensets and
the total power of the current loading
gensets is greater than the set exchange