HRX-OM-W058
Chapter 5 Display and setting of various functions
5.16 Alarm customize function HRS-R Series
Changing of operation when communication error Setting and checking
20. Press the [SEL] key once.
The set screen of changing of operation when communication error is displayed on the
digital display.
21. Select changing of operation when communication error from the table below with [▲]
key or [▼] key, and confirm by pressing “SEL”.
Table 5.16-12 List of set value
Initial value
(Default setting)
This alarm signal is not detected.
Operation continues when this alarm signal is
generated.
Operation is stopped when this alarm signal is
generated.
The monitoring time of communication error Setting and checking
22. Press the [SEL] key once.
The set screen of the monitoring time of communication error is displayed on the digital
display.
23. Select the monitoring time of communication error from the table below with [▲] key or
[▼] key, and confirm by pressing “SEL”.
Table 5.16-13 List of set value
Initial value
(Default setting)
Setting/checking are not available if the
setting of the communication error is OFF.
Sets communication error.
Set unit is 1 sec. unit.
To Next Page
Loading...
Need help?
General
