HRX-OM-O021
Chapter 3 Transport and Setting Up
HRS Series 3.1 Transport
3-1
Chapter 3 Transport and Setting Up
3.1 Transport
The product is heavy and has potential danger at transport. Also, to prevent
damage and breakage of the product, be sure to follow these instructions for
transport.
Never lay the product on its side.
The compressor oil will leak in to the refrigerant piping, which may
cause early failure of the compressor.
Only persons who have sufficient knowledge and experience about the
product and system are allowed to transport and set up the
product.
Especially pay attention to personal safety.
Drain the residual fluid from the piping as much as possible to prevent
any spillage.
To Next Page
Loading...
