SMC Networks LECP6 Series Supplementary Operation Manual

- 24 -
No.JXC※-OMW1019-A
10.2 Handling
Warning
(1) The inside of the controller and its connector should not be touched.
It may cause an electric shock or damage to the controller.
(2) Do not perform the operation or setting of this equipment with wet hands.
It may cause an electric shock.
(3) Product with damage or the one lacking of any components should not be used.
It may cause an electric shock, fire, or injury.
(4) Use only the specified combination between the controller and the electric actuator.
It may cause damage to the controller or the electric actuator.
(5) Be careful not to be caught or hit by the work piece while the electric actuator is moving.
It may cause an injury.
(6) Do not connect the power supply or power on the product before confirming the area where the
work moves is safe.
The movement of the work may cause accident.
(7) Do not touch the product when it is energized and for some time after power has been
disconnected, as it is very hot.
It may lead to a burn due to the high temperature.
(8) Check the voltage using a tester for more than 5 minute after power-off in case of installation,
wiring and maintenance.
There is a possibility of getting electric shock, fire and injury.
(9) Do not use in an area where dust, powder dust, water or oil is in the air.
It will cause failure or malfunction.
(10) Do not use in an area where a magnetic field is generated.
It will cause failure or malfunction.
(11) Do not install in the environment of flammable gas, corrosive gas and explosive gas.
It could lead to fire, explosion and corrosion.
(12) Do not apply radiant heat from a large heat source such as direct sunlight or heat treatment
furnace.
It will cause failure of the controller or its peripheral devices.
(13) Do not use the product in an environment subject to a temperature cycle.
It will cause failure of the controller or its peripheral devices.
(14) Do not use in a place where surges are generated.
When there are units that generate a large amount of surge around the product (e.g., solenoid type lifters,
high frequency induction furnaces, motors, etc.), this may cause deterioration or damage to the
product’s' internal circuit. Avoid supplys of surge generation and crossed lines.
(15) Do not install this product in an environment under the effect of vibrations and impacts.
It will cause failure or malfunction.
(16) If this product is used with a relay or solenoid valve, they should be the surge absorbing element
built-in type.

SMC Networks LECP6 Series Specifications

General

Brand	SMC Networks
Model	LECP6 Series
Category	Controller
Language	English