SMC Networks mentor 12 User Manual

MENTOR 12 USER’S MANUAL SECTION 2: BASIC CONTROL – Page 40
There are two buttons in the section corresponding to
“Measurement of binary input”.
These are marked
“Pulses” and “Frequency” respectively, and are used to
select the type of output of the converter/ energy measuring
device being tested. The number of the Digital Input selected
for the measurement is indicated on these buttons.
• To make this selection, press the button marked
“Select” which takes you to a menu where you can
select the input you wish to use just by pressing
the relative terminal as seen from the following
screen.
• For the unit conversion process, proceed in the
same way as for the analogical inputs, described
above.

SMC Networks mentor 12 Specifications

General

Brand	SMC Networks
Model	mentor 12
Category	Test Equipment
Language	English