SMC Networks raptor

Raptor
38
Functions related to measurement
Hold button. After tapping on it, the values of the measurements
are maintained, both ‘Hardware’ and ‘Calculated’
measurements, in addition to the values shown on the chronometer and the binary input.
If it were already activated, by tapping on it, the meters would be released and the
currently measured values would be shown. This mode is activated automatically when
injection is stopped due to the Stop condition having been selected. With a new injection,
this mode is deactivated automatically.
Filter button. It allows activating the average of measurements,
thereby allowing them to be stabilised in noisy environments.
Measurement averaging is for 5 seconds. However, this cycle re-starts as soon as the
variation of the measurement exceeds a certain threshold. Thus, even though this
function may be active, tracking in the event of changes is quick.