109/282
ENGLISH
Use and maintenance manual ßP700
8.1 POSSIBLE CAUSES AND REMEDIES
Following, the descriptions and relative solutions of common problems that could occur
during the normal operation of the machine.
ATTENTION!
All the checking and replacing operations on the machine, must be carried out
without voltage. In case of fire, use a CO2 exstinguisher. Avoid using powder
extinguishers.
8.2 AUDIO WARNING OF PROBLEMS
Cyclically, the program performs a number of controls. If one of these controls has a
negative result, the system produces a "Beep" and a message showing the problem
number
Tab 8.1.1
PROBLEM: CAUSE REMEDIES and
SOLUTIONS
SMOKE DURING
SEALING
HIGH TEMPERATURE
REDUCE SEALING
TEMPERATURE
THE SEALING OPENS
DURING SHRINK-
WRAPPING
SEALING BAR DIRTY OR
DAMAGED
CLEAN THE SEALING BAR OR
REPLACE IT IF DAMAGED
WRONG SEALING VALUE
PLEASE ADJUST THE
SEALING VALUE
IRREGULAR SEALING
POOR QUALITY OF FILM REPLACE FILM
SEALING DOES NOT
TAKE PLACE
SEALING VALUE TOO LOW INCREASE SEALING VALUE
THE SEALING BAR DOES
NOT RECEIVE CORRECTLY
REPAIR THE RESISTOR
INSIDE THE SEALING BAR
WORN GASKET REPLACE THE GASKET
SEALING BAR DAMAGED REPLACE THE SEALING BAR
8. ANOMALIES AND FAILURES - HOW TO REMEDY
To Next Page
Loading...
