SMORACY BEAST 3680 - START-UP PROCEDURES

To Next Page

To Previous Page

Smoracy, LLC

MODEL 3680 CONTROLS/START-UP PROCEDURES

START-UP PROCEDURES

Do not let anyone operate or maintain this machine until they have thoroughly read this manual, viewed the decals

and video tape, and follow all instructions. You can purchase additional Smoracy, LLC manuals & video tapes for

a nominal fee.

Consult your engine manual for proper break-in procedures. Various engines require somewhat different

procedures, but basically the engines need to operate at lower R.P.M.’s and loads for a specific time.

Failure to properly break-in your engine will result in poor bearing and piston ring surfaces. See Engine Manual for

proper break-in procedures.

The machine has only been run for a short time to test proper hydraulic pressures, possible leaks, etc.

STARTING THE RECYCLER

(See following page for pre start-up procedures)

After going through the pre start-up procedures on the following page, refer to the soft start manual for the proper

start-up of the Electric Beast.

DANGER

WARNING