EasyManuals Logo

Snap-On Solus Legend User Manual

Snap-On Solus Legend
143 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #97 background imageLoading...
Page #97 background image
Wi-Fi Connection / Troubleshooting Add Network Advanced (Connecting to a hidden network)
88
13.3 Add Network Advanced (Connecting
to a hidden network)
The Add Network selection allows you to connect to a network that is not
broadcasting its name (not visible in the displayed network list). These networks are
also known as "hidden" networks.
To connect to a hidden network you will first need to know the following:
Network Security Type
Open (only need SSID)
WPA or WPA2 (Pre-shared key)
WEP (WEP key)
Network name or SSID (Service Set Identifier)
Network Password
z Connecting to a Hidden Wi-Fi Network
1. From the Home screen, navigate to Tools > Settings > Configure Wi-Fi.
2. Select Add Network Advanced from the network list (scroll to end of list).
3. Select security type Open, WPA, WPA2, or WEP. Refer to the router user
manual or your IT administrator to determine the type.
4. Enter the network name or SSID
5. Enter the network password.
6. Select Connect at the prompt to connect to the network.
7. Select OK at the confirmation screen to continue using this connection, or
Forget to disconnect this connection.
13.4 Wi-Fi Testing
If you are experiencing network connection issues, an automated testing feature is
available to quickly test your network connection.
z Testing Connections
1. Before you start the automated testing procedure, turn off the diagnostic tool
and then turn it on. This clears previous testing messages from memory.
2. Connect to your desired network, see “Turning Wi-Fi On and Connecting to a
Network” on page 87.
3. From the Wi-Fi configuration screen, select the Wi-Fi Test icon to open the
network connection test screen (Figure 13-4).
Figure 13-4 Wi-Fi Test Icon
The network connection test is an automated test that begins when the screen
is displayed. Network connection systems are tested in sequence and display
a status indicator
(Red = test failed, Yellow = test is process, or Green = test completed
satisfactorily) when finished (Figure 13-5).
Connectivity of the following systems are checked:
Hardware
Router
Internet
HTTP
Web Services Network

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Snap-On Solus Legend and is the answer not in the manual?

Snap-On Solus Legend Specifications

General IconGeneral
Data LoggingYes
ConnectivityWi-Fi, USB
BatteryRechargeable lithium-ion
Weight2.2 lbs (1.0 kg)
Operating SystemAndroid
SoftwareSnap-On Diagnostics software