Soehnle 3025 - Error Messages During Taring; Display Options with the Info Key

65
b) Calling up the list of fixed tare values for taring:
Press the F1 Tare Fix key in the Tare functions level. The display shows the last fixed tare value called up.
Selection within the list
Scroll with the arrow keys.
Call the desired fixed value with F6 Accept.
Direct call via memory location number.
Enter the memory location number using the numeric keypad.
Direct call via barcode or EDP
(See chapter 7.10 Bar code management for information or ask your Soehnle Industrial Solutions service
partner).
Note
If the function read-only memory call via barcode is activated and one is called that is not contained in the
fixed memory, the error message "Error 83 - Fixed value not available" appears. You return to the weighing
mode and the selected function is deleted.
Delete Fixed tare value
To delete the tare value and the designation from the working memory, press the CL key..
6.5.12 Error messages during taring
Error 06: Taring not possible.
Possible causes:
> Empty scale,
> Scale in overload or underload,
> Tare manual input with tare value over maximum load,
> The scale shows a negative weight value.
6.5.13 Display options with the Info key
Pressing the button gives you the following options:
> F1 Tare fix
Display of stored tare fixed values (Tare-Fix memory).
> Tare key
Display of the current tare weight in the tare memory.
After pressing the key , press the key .