When the fixed value is called up, nominal quantities and tolerances for the piece check are also accepted, if
saved with .
To delete all stored reference weights, use the "Delete reference weights" function in the setting mode.
Hint
If the function read-only memory call via barcode is activated and one is called that is not contained in the
fixed memory, the error message "Error 83 - Fixed value not available" appears. You return to the weighing
mode and the selected function is deleted.
6.7.6 Totalising and Picking
This function is also available in count mode.
You can use this function to total/pick items of the same unit goods.
The totalising functions are controlled using function keys at the Counting functions level.
Totalising
means that the individual positions are weighed one after the other, the weight in the totalising memory is
added, and the scale is unloaded again after each individual weighing.
Picking
means that the weighed positions remain on the scale.
The weight is added to the total memory and the scale returns to zero without being unloaded.
It is not permitted to change the measuring point during the picking process.
Selecting Totalising or Picking
is set in the Program Settings setting mode.
The selection applies to all connected weighbridges.
In the following, the term "totalising" is used as an example.
Totalising memory for several connected scales
A central totalising memory is maintained for all connected weighing instruments.
Totalising memory capacity
A maximum of 999 bookings are possible in the total memory.
The totalising memory must then be erased.
To Next Page
Loading...
