6.6.5 Operating the totalising function
Use the function change key to call up the totalising functions level.
Plus F6
Press the F6 Plus key to transfer the weight on the weighbridge to the totalising memory. The transaction
counter and the sequential number are incremented by 1.
Before totalling again, the scale must be unloaded to at least the unload factor specified in the setting mode.
A weight value with 0 or a total without a credit is displayed with "Error 55 Place weight on scale" (if the credit
factor = 0, you only need to change the weight).
Gross, tare and net weights are added together.
Hand F5
Press the F5 Hand key to manually enter weight values and piece counts.
The entry is made via the numeric keypad and confirmed by pressing the F6 Enter key.
In the input window, you can switch between the adjusted unit, the second unit and the piece count by
pressing the function-change key . Manual entries are identified in the print document by the designation
Manual.
The transaction counter and the sequential number are incremented by 1. Weight values are added to the
weight total, piece numbers are added separately to the piece total.
Cancellation F4
You can use the F4 Cancel key to reverse or reweigh individual items.
After pressing the Cancellation key, you are prompted either to debit the scale with the weight to be cancelled
or to enter the serial number of the weight to be cancelled.
In advance, you can enter information on the current number by pressing the key combination and F5
Plus. Enter the current number of the item to be cancelled using the numeric keypad and confirm with F6
Accept.
If you do not enter a sequential number, press F6 to store the weight value from the scale. If the scale is
unloaded, you receive the error message Error 46.
Cancellation or back weighing are indicated in the print document by the name Cancellation.
The consecutive number is incremented by one during cancellation; the transaction counter is reduced by
one.
If the transaction counter is set to 0, no further cancellation is possible, indicated by error message Error 48.
Sum F3 or with the CL key
By pressing the F3 Sum key, the summation is completed.
The display now shows the gross, tare, net and piece total, as well as the transaction counter and sequential
number of the last operation.
To Next Page
Loading...
