3 Counting
+/- tolerance separated Selection off or on
Selection on causes that + and - tolerance for the piece control can be defined and
queried separately.
Selection Off causes the tolerance to be queried only once and is therefore the
same for + and -.
Factory setting: off
Data record outside tolerance
Selection within or out of
Here you specify whether a data record may only be sent to a printer or EDP
system within the tolerance or also outside it. If the data record is also accepted
outside tolerance, it is marked with a special character in this case.
Factory setting: out of
Total outside tolerance Selection within or out of
Here you define whether totals in the totalising memory may only be made for
values within the tolerance or also for values outside the tolerance.
Factory setting: Out of
Clear total before new
reference weight
Select off or on.
Selection On means that the totalising memory must first be cleared before a new
reference weight can be determined. This prevents different parts from being
added together.
Factory setting: off
Total or picking Select Totalise or picking for the following settings.
Totalising means that the individual items are removed from the scale after they
have been stored in the totalising memory.
Picking means that the individual items remain on the scale after they have been
stored in the totalising memory and that the next items are placed on the scale.
Factory setting: Totalising
Auto total / picking Select off or on.
On means that only the first position at a time needs to be stored by pressing the
Plus key, all other positions are automatical
ly added after weight has been reached
and stability is stored in the totalising memory.
Factory setting: Off
Reset consecutive number Selection of the condition under which the consecutive totalling / picking number
is to be reset.
> not active
> Clear total memory
> On/Off
> Function key (activates a separate function key)
Factory setting: not active
To Next Page
Loading...
