ID86 Bat Voltage Low Shut
Battery voltage is too low & cause
ME3000SP to switch OFF
ME3000SP will switch OFF when battery voltage is
too low. This is a protection for battery.
ID94
consistent
Contact SOFAR technical support to upgrade
software.
ID95 CommEEPROMFault
The Communication board EEPROM
is fault
ID95-ID96 are internal faults of ME3000SP, turn OFF
the DC isolator & AC circuit breaker, wait f
minutes, then turn ON the DC isolator and turn ON
the AC circuit breaker. Check whether the problem is
solved. If no, please contact SOFAR technical
support.
ID96 RTCFault RTC clock chip is fault
ID98 SDfault The SD card is fault
Normally ID98 is caused by loose SD card holder.
Click & take out SD card, press SD card holder then
insert SD card back can normally solve this problem.
ID100 BatOCD
Battery over current discharging
protect ID100-
ID103 is battery fault. If this fault occurs
occasionally, wait few minutes to see whether the
problem is solved.
If this fault occurs frequently, please contact SOFAR
technical support.
Discharging short circuit protect
Battery high voltage protect
ID103 BatUV Battery low voltage protect
ID104 BatOTD
Battery high temperature protect
while discharging
Make sure battery is in a well-ventilated place.
Try to decrease the max discharge (A) or/and max
charge (A) to see if the problem is solved.
ID105 BatOTC
Battery high temperature protect
while charging
ID106 BatUTD
Battery low temperature protect
while discharging
Try to increase the ambient
battery.
ID107 BatUTC
Battery low temperature protect
while charging
To Previous Page
Loading...
Need help?
General
