Figure 5.8 Cable wiring between energy storage cabinet and battery cabinet
Procedure
Step 1 Locate the parallel cable that comes with the random cabinet, containing two power cables
(one positive and one negative, with plugs at both ends) and two sets of signal cables (with signal
terminals at both ends).
Step 2 Plug the power and signal cables into the energy storage cabinet first, make sure the
terminals have been plugged into place and locked, and then according to the cable identification, lead
them to the corresponding interface wiring of the battery cabinet of the parallel cabinet.
Step 3 After all the cables of the parallel cabinet are connected, tie the cables to fix them, and
check whether the plug is plugged in place again. (Judgement method: 1, can hear the sound of
installation in place, 2, reverse pull the cable without loosening)
Step 4 When wiring is complete, gently tug on the cable to ensure that margin is left.
Step 5 Install the cable guard cover.
To Next Page
Loading...