Figure 5.23 Schematic diagram of installing fire hoses
Figure 5.24 Schematic diagram of installing quick plug plugs at both ends
Step 3: After the fire hose is installed in place, install the clip of the fire hose and tighten the clip
with two M4 screws.
5.6 AC power cord connection of PCS
The PCS AC power cable wiring is located on the input side of the three-phase AC moulded case
circuit breaker in the junction box in the liquid-cooled compartment of the energy storage cabinet.
The AC power line wiring is shown below.
To Next Page
Loading...