liquid cooling hose for the cabinet includes four steps: opening the rotating cover plate, installing the
quick connect fire pipeline, installing the pipeline clamp, and closing the rotating cover plate.
Step 1: Remove the fixing screws of the rotating cover plate on the top of the cabinet and open
it by rotating it. And support the support rod well.
Figure 5.21 Schematic diagram of disassembling the screws of the rotating cover plate
Figure 5.22 Schematic diagram of the state of the top cover supported by the support rod
Step 2: Install the hose of the fire protection cabinet into the quick connector of the cabinet top
pipeline. During installation, pull the outer iron ring of the quick connector backwards and insert the
fire protection hose into place. After installation, use your hands to pull it. If it cannot be pulled, it
means it has been installed in place. Install quick plug plugs at both ends of the fire protection pipeline
on the top of the cabinet. As shown in the figure.
To Next Page
Loading...