Electrical Connections
64
Step 2. Insert the stripped cable into OT terminal and put on heat-shrink tubing.
28-30 mm
Step 3. Crimp OT terminal with a crimping tool. Pull the heat-shrink tubing
over the stripped section of the OT terminal and use a heat gun to shrink it so
that it can be rmly contacted with the terminal.
Crimping Tool
Heat gun
The inverter provides a DONGLE port, which can transmit data of the inverter
to the monitoring website via WiFi Plus Dongle, 4G Dongle, and LAN Dongle.
(If necessary, purchase products from us)
6.6 Monitoring Connection (Accessories)
■ WiFi Connection diagram
Router
Cloud
Step 4. Find the ground connection port on the inverter, and screw the ground
wire on the inverter with an cross pan screw.
M4
1
.
5±0.1 N·m
To Next Page
Loading...
