7-9
BDP-BX2/S360
(Screen 1)
Factory Initialize
[ENT] Start Initialize
[RET] Return to Top Menu
Factory Initialize (Factory Default Settings)
Overview:
This is used to return the set to the factory default settings.
This returns all modified settings to the factory default settings.
However, the initialization process is not complete by only performing this operation.
After this operation, the set must be rebooted to complete the initialization process.
A normal restart is used to reboot. Initialization is not completed by restarting in
Service Mode or other special mode.
Operations:
Screen 1
To return the set to the factory default settings, press [ENT] in this screen.
All saved titles are erased.
[ENT] Initialize the set to the factory default state
[RET] Return to Service Mode top menu
Screen 2
This is the screen displayed after initialization is executed.
Initialization is completed by rebooting the set.
Turn the AC power supply off and then on again.
You can continue to perform other Service Menu operations before rebooting.
Display panel:
During initialization: SETTING
When initialization was successful: INIT-OK (Screen 2)
When initialization failed: INIT-NG
(Screen 2)
Factory Initialize
Reboot to complete.
[RET] Return to Top Menu
HELP : [RET]
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com
To Next Page
Loading...
