6-6
CCD-TRV138/TRV238E/TRV338/TRV438E
H
A=B
C=D
AB B
CD
A
Enlargement
V
Electronic beam scanning frame
CRT picture frame
B
A
Difference in level
Yellow
Cyan
Green
White
Magenta
Red
Blue
Yellow
Cyan
Green
White
Magenta
Red
Blue
Color bar chart (Color reproduction adjustment frame)
Fig. a
(VIDEO terminal of A/V jack
output waveform)
Fig. b (monitor TV picture)
Adjust the camera zoom and direction to
obtain the output waveform shown in Fig. a and
the monitor TV display shown in Fig. b.
1-1-3. Precaution
1. Setting the Switch
Unless otherwise specified, set the switches as follows and perform adjustments without loading cassette.
1. POWER switch (SS-5100 block) ..........................CAMERA
2. FOCUS (CF-5100 block) ..................................... MANUAL
3. BACK LIGHT (CF-5100 block) .................................... OFF
4. PROGRAM AE (MENU setting) ................................ AUTO
5. NIGHTSHOT PLUS switch (Lens block) ..................... OFF
6. EXPOSURE (CF-5100 block) .................................... AUTO
7. P EFFECT (MENU setting) ........................................... OFF
8. D ZOOM (MENU setting) ............................................. OFF
9. DEMO MODE (MENU setting) .................................... OFF
10. 16 : 9 WIDE (MENU setting) ........................................ OFF
11. DISPLAY (MENU setting) ............................................ LCD
2. Order of Adjustments
Basically carry out adjustments in the order given.
Fig. 6-1-4
3. Subjects
1) Color bar chart (Color reproduction adjustment frame)
When performing adjustments using the color bar chart, adjust
the picture frame as shown in Fig. 6-1-4. (Color reproduction
adjustment frame)
2) Clear chart (Color reproduction adjustment frame)
Remove the color bar chart from the pattern box and insert a
clear chart in its place. (Do not perform zoom operations during
this time)
3) Chart for flange back adjustment
Join together a piece of white A0 size paper (1189mm × 841
mm) and a piece of black paper to make the chart shown in
Fig. 6-1-5.
Note: Use a non-reflecting and non-glazing vellum paper. The
size must be A0 or larger and the joint between the white
and black paper must not have any undulations.
Fig. 6-1-5
Black
White
841 mm
1189 mm
To Next Page
Loading...
