Sony CCD-TRV138 - Adjusting Items when Replacing Main Parts and Boards

6-2
CCD-TRV138/TRV238E/TRV338/TRV438E
1-1. Adjusting Items when Replacing Main Parts and Boards
• Adjusting items when replacing main parts
When replacing main parts, adjust the items indicated by z in the following table.
Table 6-1-1 (1)
Note 1: When replacing the drum assy or mechanism deck, reset the data of page: 7, address: A4 to A6.
(Refer to “Record of Use Check” of “6-4. SERVICE MODE”)
Note 2: When replacing the video light, reset the data of page: 7, address: CE and CF.
(Refer to “Record of Use Check” of “6-4. SERVICE MODE”)
Note 3: CCD-TRV338/TRV438E only
Replaced part
Block replacement Mounted part replacement
Adjustment Section Adjustment
(LCD panel) (Fluorescent tube) (Drum assembly) (Note 1) (Capstan motor) (CCD imager) (YAW, PITCH sensor) (Note 3) (Timing generator) (S/H, AGC, A/D CONV.) (Camera/VTR process, Lens control) (REC/PB AMP) (EVR) (Audio/Video process) (LCD driver)
Lens device Video light (Note 2) LCD block LCD901 LCD block ND901 Mechanism deck (Note 1) Mechanism deck M901 Mechanism deck M902 CD-465 board IC951 SI-039 board SE751/752 VC-341 board IC151, X151 VC-341 board IC152 VC-341 board IC301 VC-341 board IC481 VC-341 board IC251 VC-341 board IC801 PD-204 board IC6001
Initialization of 8, A, C, D,
E, F, 1F page data
Initializing of 8, A, C, D, E, F, 1F page
data
Camera HALL adj. z
Flange back adj. zz
Optical axis adj. zz
Color reproduction adj. zz
LV standard data input zz
AWB standard data input zz
Auto white balance adj. zz
Angular velocity sensor output check
and steadyshot check (Note 3)
z
LCD LCD level adj. z
LCD V-COM adj. zz
LCD White balance adj.
zz z
Servo CAP FG offset adj. zz
Switching position adj.
zz
Video 28 MHz origin osillation adj. zz
AFC f
0 adj. z
LINE OUT level adj. zz
REC Y current adj. zz
REC C/AFM current adj.
zz
Audio BPF f
0 adj. z
1.5 MHz deviation adj.
z
Mechanism Tape path adj.
zzz