Sony DCR-TRV6 - Playing Back a Tape

Playing back a tape
Press DISPLAY on your camcorder or the Remote Commander supplied with your
calllcoFder.
The indicators appear oil tile LCD screen.
To make the indicators disappear, press DISPLAY again.
DATA CODE
Using the data code function
Your can-leorder auton-latieally records not only inlages oil the tape but also the
recording data (date/time o1"various settings when recorded) (Data code).
Press DATA CODE on your camcorder o1"the Remote Commander in the playback
mode.
The display changes as follows:
date/time -+ various settings (SteadyShot, white balance, gain, shutter speed, aperture
value, expostne mode) -+ no indicator
Date/time
UL 4 2OOO
12055_ A_4
Not to display various settings
Various settings
( --SteadyShot OFF indicator
/ ( Exposure mode indicator
I _ Au'rof....... White balance indicator
Gain indicator
Shutter speed indicator
Aperture value
Set DATA CODE to DATE in the menu settings (p. 85).
The display changes as follows:
date/time _+ no indicator
Recording data
Recording data is your camcorder's information when you have recorded. In the
recording mode, the recording data will not be displayed.
When you usethe data code function, bars (...... ) appear if:
•A blank portion of the tape is being played back.
•The tape is unreadable due to tape damage or noise.
•The tape was recorded by a camcorder without the date and time set.
Data code
The data code is displayed on the TV screen ifyou connect your camcorder to the TV
(p. 28).
26