Sony DCR-TRV6 - Labeling a Cassette

Labeling a cassette
If you use a tape witb cassette memory, you can label a cassette. The label can
consist of up to 10chalacters and is stored in cassette memory. When you insert
tile labelled cassette and turn tile power on, the label is displayed for about five
seconds.
(1) Insert the cassette you want to label.
(2) Set the POWER switch to VCR.
(3) Press MENU to display the menu.
(4) Turn the SEL/PUSH EXEC dial to select _, then press the dial.
(5) Turn the SEL/PUSH EXEC dial to select TAPE TITLE, then press the dial. Tape
title display appears.
(6) Turn the SEL/PUSH EXEC dial to select the cohmm of the desired character,
then press the dial.
(7) Turn the SEL/PUSH EXEC dial to select the desired character, then press the
dial.
(8) Repeat steps 6 and 7 until you finish the label.
(9) Turn the SEL/PUSH EXEC dial to select [SETI, then press the dial.
The label is stored in memory.
6-8
4,5 cMsEt
t_ CM SEARCH
,1_ TITLEERASE
TITLE DSPL
ERASE AU
i _rc I_' Cbl SEARCH
_;t TITLEERASE
_TC TAPE T _TLE_
L_I :.........
KLMN O ' , /-
PQRST [ ÷ ]
[MENU] END
TAPETITLE_ r_ TAPIT[TLE_
ABCDE 12345 ABCDE 12345
FGHIJ 6789O FGHIJ 67890
[RiN_' ;/[ _.No' -PQRST [ PQRST [
UVWXY {SET} UVWXY [SET)
z& _1 z& ?t
[MENU] END [MENU] END
TAPET_TLE_ "_ TAPII[TLE_
M..........
ABODE 12345 ABODE 12345
FGHIJ 67890 FGHIJ 67890
K_O' ;/[ K_O' -
PQRST [ PQRST [
UVWXY {SETI UVWXY [SET]
z& ?1 z& ?_
{MENU]END [MENU]END
5'
83