Quickly locating a scene using the zero
set memory function
Your camcorder goes forward or backward to automatically stop at a desired scene
having a tape counter value of ' 0:00:00". You can do this with the Remote Commander.
(1) In the playback mode, press DISPLAY.
(2) Press ZERO SET MEMORY at tile point you want to locate later. Tile tape
counter shows "0:00:00" and the ZERO SET MEMORY indicator flashes.
(3) Press • wherl you want to stop playback.
(4) Press <1<1 to rewind the tape to the tape counter's zero point. The tape stops
automatically when the tape counter reaches approximately zero. The ZERO
SET MEMORY indicator disappears and the time code appears.
(5) Press I_. Playback starts.
_--- ZERO SET MEMORY
IP_ DISPLAY
Notes
• When you press ZERO SET MEMORY before rewinding tile tape, the zero set memory
fimction will be canceled.
• There may be a discrepancy of several seconds fl'om tile time code.
• The zero set memo1T f\mction may not work when there is a blank portion between
pictures on a tape.
The zero set memory functions also in the recording standby mode
When you insert a scene in tile middle of"a recorded tape, press ZERO SET MEMORY at
the point you want to end tile insertion. Rewind the tape to tile insert start point, and
strut recording. Recording stops automatically at tile tape cotmter zero point. Your
camcorder returns to tile standby mode.
48
To Next Page
